Industry Information

Update January 07, 2019

How to choose ball bearing and roller bearing?

1. There are two camps in the current auto bearing shopping mall; one is the most used roller bearing; the other is the double-row angular touch ball bearing and many other foreign bearings. 2. In...

Update January 03, 2019

Tapered roller bearing and water pump shaft bearing device

The device of tapered roller bearing and water pump shaft bearing should pay attention to the following aspects: First, the bearing device: The bearing device must be carried out under boring and...

Update December 28, 2018

Thin-walled bearing

The thin-walled bearing has completed the extremely thin bearing section; it has also completed the miniaturization and weight reduction of the product. The diversity of the product has expanded its...

Update December 27, 2018

Bearing common sense: difference between pitch bearing and yaw bearing

1. Anti-corrosion treatment of pitch bearings and yaw bearing external alignment. In order to meet the anti-corrosion requirements of yaw bearings, we use arc spraying long-term anti-corrosion...

Update December 24, 2018

Eccentric thrust needle roller bearing

Thrust bearings used in the installation of the engine and torque converter are usually installed with the engine and torque converter in an eccentric condition. If eccentricity is not allowed, the...

Update December 21, 2018

Structure and application of thrust roller bearing

Thrust roller bearings are used for axial and radial combined loads subject to axial load, but radial loads must not exceed 55% of axial load. Compared with other thrust roller bearings, this type of...

Update December 11, 2018

Double row tapered roller bearing

Double row tapered roller bearings are derived from the paired layout of two single row tapered bearings in automotive hub components. The larger the contact angle of the double row outer ring...

Update December 03, 2018

Reasons and influence of temperature change of steam engine bearing and thrust bearing

Support bearing temperature Reasons for change: (1) bearing oil intake reduced into debris, oil hole is not smooth; (2) oil cooler oil temperature change; (3) turbine load increase axial heat...

Update November 23, 2018

Do you know the clearance grade of the bearing?

Radial internal clearance code: NSK, for example C2 < CN < C3 < C4 < C5CN (some factories call it C0) is the standard clearance, greater than the standard clearance is called a large...

Update November 22, 2018

Make it easier to change bearings

"We need only a screwdriver to easily remove the side cover of the slider on the linear guide rail. The principle of drylin W interchangeable linear sliding bearings is so simple." ReneAchnitz said...