Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
2019-04-24
(4) The installation plane must be clean and flat, and must not have iron filings, burrs or other debris.
(5) For the installation of the Slewing Ring, the bolts with the strength registration should be selected. Bolts and nuts shall comply with the requirements of GB3098.1 and G B3098.2. Spring washers are prohibited.
2. installation
(1) Place the slewing bearing horizontally on the mounting bracket, and place the soft belt and the blocking position in the non-load zone, the non-frequent load zone or the light load zone.
(2) Check the contact between the slewing bearing plane and the mounting plane with a feeler gauge. If there is a gap, the material should be filled with the material to fill the gap to prevent the slewing bearing from deforming after the bolt is tightened.
(3) The mounting bolts should have sufficient pre-tightening force, and the pre-tightening force generated by the pre-tightening force on the bolts should be within the range of 0.6-0.7 times of the yield point of the bolts.
(4) Before the mounting bolts are tightened, the large and small gears must be meshed and adjusted. As shown in Figure 1 (side clearance), especially for gear quenching products, the maximum point of the Slewing Ring Gear (marked with green paint) should be meshed with the pinion. Meet the requirements.
(5) Tighten the mounting bolts symmetrically in the 180° direction.
Share to:
Send Inquiry
Mr. Derrick
Email:
Send Inquiry Tel:86-0379-65188961
Fax:86-0379-65188961
Mobile Phone:+8613721655534
Email:
Address:No.1 Nan Chang Road, Luoyang, Henan
Related Products List
Mobile Site
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.