How long does the grease of the slewing bearing fill once? What should I pay attention to when cleaning the slewing bearing?
Slewing bearings are widely used in construction machinery and other equipment platforms, mainly used in construction machinery such as light industrial machinery, concrete machinery, lifting machinery, sand mixers and other equipment. In the process of using the Slewing Bearing, the filling of the grease plays an important role in the normal use of the slewing bearing. First of all, after installing the slewing bearing in the correct step, it is necessary to fill the appropriate amount of grease. At this time, it is necessary to pay attention to the fact that when filling, the slewing bearing should be filled while filling, so that the grease can be evenly distributed. Secondly, everyone knows that some grease will be slowly lost during the operation of the slewing bearing. At this time, it is necessary to add it again to avoid malfunction of the machine and affect normal operation. It is generally recommended that you replenish the slewing bearing in normal operation at intervals of 50-100 hours. Commonly used greases include calcium-based greases, lithium-based greases, aluminum-based greases, and high-temperature greases. Users can choose the most suitable grease according to the specific conditions. Grease can be used according to the following parameters: Timely filling of grease is very important, but regular cleaning is also very important. Before installing the slewing bearing, it is necessary to clean the plane of the supporting car and remove the oil, burrs and some debris. Before installation, there is a A clean working environment. When using the installed slewing bearing, the sleeve and the sleeve and the parts between the column and the column are not interchangeable. To clean and clean when cleaning, disassemble according to the bearing installation drawing. The restoration after cleaning should be correctly installed according to the installation drawing. The upper and lower halves should be assembled according to the original drilling position to avoid affecting the normal use of the slewing bearing. Cleaning of the flank is recommended every 10 days.